Introducing the all new RSe10 lightweight wheels. As you can expect from NEUSPEED designer, the RSe10 features clean and simple spoke profile but yet carries enough detail around the lug hole area to separate itself from other split 5-spoke out there in the market. 

Each RSe10 is spec-ed specifically for the assigned vehicle, which translates to complete direct bolt-on fitment utilizing factory lug bolts, center caps, as well as tire pressure monitoring sensors (if applicable) – No spacers, No hub rings!!

Weighing just a mere 21.5 lbs, The RSe10 wheels will enhance your driving experience cosmetically as well as performance by reducing the rotational mass or unsprung weight

Specs

• Size: 19x8.5
• Offset (E.T.): +45mm
• PCD (Bolt Pattern): 5-112
• Center Bore: 57.1mm
• Weight: 21.5 lbs.

Recommended Tire Size:

*These sizes are only to be used as a guide*

*For Vehicles that are stock height or slightly lowered.*

*Extremely low vehicles may need a tire width that is smaller*

Wheel Bolts:

Neuspeed Wheels use the OEM wheel bolt size and design. You can reuse your OEM wheel bolts with these wheels! 

• OEM Wheel Bolt Specs:
• Thread Type: 14 X 1.5"
• Thread Length: 28mm Shank
• Seat Type: Ball 
• Head: 17mm Hex

Replacement OEM Wheel bolts: Otis Inc 27mm Ball Seat Wheel Bolts

Notes:

• RSe wheels are OEM TPMS (Tire Pressure Monitoring System) compatible.
• Every RSe wheel comes with 'RS' center cap. However, one can choose to utilize early style OEM Audi or VW center cap as well as mounting lug bolts, which are not included with the wheel.
• Audi cap part #: 4B0 601 170
• VW cap part #: 3B7 601 171
• Compatible with Brembo, Stoptech and many other BBKs without wheel spacers/adapters.
• Audi RS3 (8Y) Fitment Note: Front fenders are much wider than the rears. For a square setup, +20mm front spacer is recommended to achieve flush fitment matching the rear.