Hawk Performance Ceramic Brake Pads - Front (A6, CC VR6 FWD)

LOWEST PRICE GUARANTEED
$194.39
$215.99
You Save $21.60
FREE Shipping
SKU: 102289
MPN: HB515Z.760

Product Details

Description

Performance Ceramic ('Z' Compound Code)
Hawk Performance offers a premium, high performance, ultra-low dust, low noise compound called Performance Ceramic.

Performance Ceramic is engineered to reduce brake NVH (Noise, Vibration and Harshness) creating a quieter performing brake pad. Furthermore, the ceramic brake pad formula has a linear friction profile that allows your ABS brake system to work more effectively. With Performance Ceramic you can expect reduced brake pad wear, lower dust output levels and a rotor-friendly brake pad.

Specs

  • Position: Front
  • w/0.760 Thickness

Notes

  • Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance.

Product Features

  • Extremely quiet–engineered to reduce brake NVH (Noise, Vibration and Harshness)
  • Increased Stopping Power
  • Increased Rotor Life
  • Extended Pad Life
  • Ultra-Low Dust
  • Stable Friction Output

installation

Installation Procedure

  1. Install brake pads properly. Be sure pads are securely positioned in the caliper.
  2. Flush system with fresh brake fluid.
  3. Check all hydraulic parts for excess wear and tear.
  4. Check disc for proper thickness, parallelism, and lateral runout.
  5. Check disc for scoring or grooves over .012”depth. If either applies, resurfacing is required.
  6. If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130-grit sandpaper using moderate pressure. Use soap and water to clean disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid.
  7. Inspect calipers for freedom of movement. Lubricate where necessary.

Bed-In/Burnishing Instructions

  1. After installing new brake pads, make 6-to-10 stops from approximately 30-35 MPH applying moderate pressure.
  2. Make an additional 2-to-3 hard stops from approximately 40-45 MPH.
  3. DO NOT DRAG BRAKES!
  4. Allow at least 15 minutes for the brake system to cool down.
  5. After step 4 is completed, your new Hawk Performance brake pads are ready for use.

warranty

Fitment Guide

Does this fit my vehicle?

Fitment Guide
Start Year End Year Make Model Submodel Cyl Lit Fuel FuelDel ASP EngDesg Notes
1998 2004 Audi A6
A6 Quattro
Base
Avant
V6 2.7
2.8
3.0
GAS FI NA
T
AFC
AHA
ATQ
AVK
BEL
APB
 
2009 2013 Volkswagen CC VR6 Sport
VR6 Lux
V6 3.2 GAS FI NA BLV
CNNA
 

Customer Pictures

No images yet

Customer Reviews

No reviews have been written for this product.
Write a Review