Hawk Performance Ceramic Brake Pads - Rear (Audi A6/RS6/S4/S6)

LOWEST PRICE GUARANTEED
$139.49
$154.99
You Save $15.50
FREE Shipping
SKU: 102321
MPN: HB553Z.652

Product Details

Description

Performance Ceramic ('Z' Compound Code)
Hawk Performance offers a premium, high performance, ultra-low dust, low noise compound called Performance Ceramic.

Performance Ceramic is engineered to reduce brake NVH (Noise, Vibration and Harshness) creating a quieter performing brake pad. Furthermore, the ceramic brake pad formula has a linear friction profile that allows your ABS brake system to work more effectively. With Performance Ceramic you can expect reduced brake pad wear, lower dust output levels and a rotor-friendly brake pad.

Specs

  • Position: Rear
  • w/0.652 Thickness

Notes

  • Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance.

Product Features

  • Extremely quiet–engineered to reduce brake NVH (Noise, Vibration and Harshness)
  • Increased Stopping Power
  • Increased Rotor Life
  • Extended Pad Life
  • Ultra-Low Dust
  • Stable Friction Output

installation

Installation Procedure

  1. Install brake pads properly. Be sure pads are securely positioned in the caliper.
  2. Flush system with fresh brake fluid.
  3. Check all hydraulic parts for excess wear and tear.
  4. Check disc for proper thickness, parallelism, and lateral runout.
  5. Check disc for scoring or grooves over .012”depth. If either applies, resurfacing is required.
  6. If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130-grit sandpaper using moderate pressure. Use soap and water to clean disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid.
  7. Inspect calipers for freedom of movement. Lubricate where necessary.

Bed-In/Burnishing Instructions

  1. After installing new brake pads, make 6-to-10 stops from approximately 30-35 MPH applying moderate pressure.
  2. Make an additional 2-to-3 hard stops from approximately 40-45 MPH.
  3. DO NOT DRAG BRAKES!
  4. Allow at least 15 minutes for the brake system to cool down.
  5. After step 4 is completed, your new Hawk Performance brake pads are ready for use.

warranty

Fitment Guide

Does this fit my vehicle?

Fitment Guide
Start Year End Year Make Model Submodel Cyl Lit Fuel FuelDel ASP EngDesg Notes
2005 2011 AUDI A6 QUATTRO BASE V8 4.2 GAS FI NA ALL  
2009 2011 AUDI A6 QUATTRO BASE
AVANT
V6 3.0 GAS FI S ALL  
2007 2008 AUDI RS4 BASE
CABRIOLET
V8 4.2 GAS FI NA ALL  
2003 2003 AUDI RS6 ALL ALL ALL ALL ALL ALL ALL  
2005 2009 AUDI S4 BASE
AVANT
CABRIOLET
V8 4.2 GAS FI NA BHF  
2007 2011 AUDI S6 BASE V10 5.2 GAS FI NA ALL  

Customer Pictures

No images yet

Customer Reviews

No reviews have been written for this product.
Write a Review