Hawk Performance Ceramic Brake Pads - Rear (Audi A4/A6/A8/S4/S6/TT, VW Golf/Jetta/Passat)
Talk to an Expert
Need Help? Verify product fitments and get personalized product recommendations from a Modded Euros sales tech.
Product Details
Description
Performance Ceramic ('Z' Compound Code)
Hawk Performance offers a premium, high performance, ultra-low dust, low noise compound called Performance Ceramic.
Performance Ceramic is engineered to reduce brake NVH (Noise, Vibration and Harshness) creating a quieter performing brake pad. Furthermore, the ceramic brake pad formula has a linear friction profile that allows your ABS brake system to work more effectively. With Performance Ceramic you can expect reduced brake pad wear, lower dust output levels and a rotor-friendly brake pad.
Specs
- Position: Rear
- w/0.642 Thickness
Notes
- Properly bedding-in new brake pads results in a transfer film being generated at the pad and rotor interface to maximize brake performance.
- For Rear Brakes W/ "Bosch" cast into the caliper body
Product Features
- Extremely quiet–engineered to reduce brake NVH (Noise, Vibration and Harshness)
- Increased Stopping Power
- Increased Rotor Life
- Extended Pad Life
- Ultra-Low Dust
- Stable Friction Output
OE Numbers
- 1H0698451F
installation
Installation Procedure
- Install brake pads properly. Be sure pads are securely positioned in the caliper.
- Flush system with fresh brake fluid.
- Check all hydraulic parts for excess wear and tear.
- Check disc for proper thickness, parallelism, and lateral runout.
- Check disc for scoring or grooves over .012”depth. If either applies, resurfacing is required.
- If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130-grit sandpaper using moderate pressure. Use soap and water to clean disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid.
- Inspect calipers for freedom of movement. Lubricate where necessary.
Bed-In/Burnishing Instructions
- After installing new brake pads, make 6-to-10 stops from approximately 30-35 MPH applying moderate pressure.
- Make an additional 2-to-3 hard stops from approximately 40-45 MPH.
- DO NOT DRAG BRAKES!
- Allow at least 15 minutes for the brake system to cool down.
- After step 4 is completed, your new Hawk Performance brake pads are ready for use.
warranty
Lifetime Warranty
Customer Pictures
No images yet
Customer Reviews
No reviews have been written for this product.
Write a Review